NUMEVAROHome

Calculators / masonry and wall assemblies

One wall.
Or the whole building.

The same calculator handles a single wall and a full multi-storey material takeoff. A wall can have one masonry layer or a complete assembly with masonry, insulation, cavity, membrane and finish layers.

single-leafcavity wallmasonry veneerconfined masonryRC infillpartition

Full calculator

Walls / layers / materials

Quick mode and whole-building mode use the same data model. You can start with one wall and later switch to a whole building without changing calculators.

Calculation scope

These are not two separate calculators. You only change how you work with the same project data.

Product catalogue for the selected layer

Use “Select catalogue product” on a layer. The shared catalogue assigns the selected product to that exact layer.

Select a layer first.

This result is for material and cost planning. Structural capacity, reinforcement, lintels, wall ties and connection details should come from an appropriate verified technical source — for example manufacturer/system documentation, project information, a verified regional table or another suitable source. Measurements may be used for geometry where appropriate, but do not replace structural design data. Do not guess safety-critical parameters.

Result

Enter wall data

The material summary will appear automatically.

One architecture

A product is not a technology, and a language is not a market.

The calculator stores geometry, wall assembly, layers, exact products, market, units and technical-data source separately. The same module can therefore support different construction systems without creating a country-specific calculator.